|
|
Boat Modules
 These specially-designed Naps modules are suitable for marine environments, thanks to the fully sealed laminate and stainless steel construction. The low profile and integral mounting holes make them particularly suitable for mounting on boat decks, even when the deck is slightly curved. The Modules are protected from dirt, moisture and impact by a tough fluoropolymer front film. Featuring the highest standards of construction, they are able to continue to perform efficiently while withstanding the harshest environments.
Key features:
- Efficient conversion of both direct and diffuse light
- Marine-design; moisture resistance, UV stability, and electrical isolation
- Durable thanks to tough, fluoropolymer front surface for resistance to abrasion, tears and punctures
- Easy installation with integral mounting holes
- Wired-in bypass diodes reduce the change of damage from partial array shading
- Tested for a wide range of operating conditions (-40°C to + 85°C)
- Designed to meet or exceed the environmental requirements of IEC61215
|
Power Specifications*
|
NP13RSS
|
NP26RSS
|
NP40RSS
|
NP52RSS
|
|
|
Maximum Power (+/- 5%)
|
13
|
26
|
40
|
52
|
Wp
|
|
Current (normal)
|
0.75
|
1.5
|
2.3
|
3.0
|
A
|
|
Current (with Naps MaxPower)
|
1.0
|
2.0
|
3.1
|
3.8
|
A
|
|
Voltage (typical at max power)
|
17.3
|
17.3
|
17.3
|
17.3
|
V
|
|
Short Circuit Current (typical)
|
0.8
|
1.7
|
2.3
|
3.2
|
A
|
|
Open Circuit Voltage (typical)
|
21.6
|
21.6
|
21.3
|
21.6
|
V
|
|
Physical Characteristics
|
|
|
|
|
|
|
Length
|
592
|
592
|
700
|
735
|
mm
|
|
Width
|
248
|
450
|
545
|
665
|
mm
|
|
Edge thickness
|
4
|
4
|
4
|
4
|
mm
|
|
Weight
|
2.2
|
3.8
|
5.6
|
7.2
|
kg
|
* Values refer to standard test conditions of 1000 Wm-2 solar irradiance, 25°C cell temperature, Air Mass 1.5
| |
